When patching stops making sense
Repiping replaces the water supply lines in a house when the existing ones are failing. In North Miami Beach, callers describe pinhole leaks, rusty or discolored water, low pressure and repeated repairs in different places. Our repiping plumbers assess the home, explain the options and schedule the work.
NMB Water's 2025 report says brown or yellow water, stained fixtures and a metallic taste can signal rust or iron buildup, often from aging pipes or sediment, and it recommends a licensed plumber check for old galvanized pipe. That is exactly what we look at.
Signs it is time
- Pinhole leaks or green stains on copper.
- Rusty or discolored water, especially after the water sits unused.
- Low pressure at several fixtures.
- Repeated repairs at fittings.
- Galvanized steel pipe in an older section of the house.
Pipe materials compared
| Material | Strengths | Trade-offs |
|---|---|---|
| PEX | Flexible, fewer fittings, quick to install | Not for outdoor sun exposure. |
| Copper | Long track record, sturdy | Higher material cost. |
| CPVC | Rigid, affordable | Can become brittle over time. |
Which material suits your house depends on the layout and your budget. We explain the trade-offs rather than push one.
Want a repipe assessment?
Call to schedule. Same-day appointments are offered when available.
How a repipe goes
- Assess
We review the pipe, test pressure and locate problem areas.
- Plan
We map the new lines, decide wall openings and explain the schedule.
- Install
New lines go in, usually with the water off for part of the day.
- Test and patch
We pressure test, restore the water and discuss drywall patching.
PEX or copper in a South Florida home
Both materials work here. PEX bends around corners, uses fewer fittings and goes in faster, which helps in an occupied house. It should not sit in direct sun, so exposed outdoor runs need protection or a different material.
Copper is rigid and long-lived and carries a higher material cost. In homes with a mix of old materials, we often combine them, using copper where the pipe is exposed and PEX inside walls. We explain the choice and the warranty on each.
What happens to your walls
A repipe needs access to pipe runs, and in a slab home most runs are in the walls and attic. We cut small openings, route the new lines and patch to a paint-ready surface unless you have arranged otherwise.
Planning matters more than speed. We map each opening before cutting so the patching is limited to what the job needs.
Living through a repipe
Water is off while each section is tied in, and we tell you the windows so you can plan showers and cooking. In a condo, we coordinate shutoff times with the building.
After the work, we flush the new lines and check every fixture. If you have a water softener or filter, we reconnect it and confirm the bypass works.
Questions to ask any repipe contractor
- Which material will you use and why for this house?
- How many wall and ceiling openings do you expect and who patches them?
- How long will the water be off each day?
- Is the plumbing licensed in Florida? You can look up any plumber on the state DBPR licensing portal.
- What does the warranty cover and for how long?
Choosing pipe the code allows
The Florida Building Code, Plumbing, based on the IPC, lists approved supply pipe materials. Copper, PEX and CPVC are common choices, each with trade-offs in cost, noise and how it handles the water in your area. We explain each, and permit rules depend on the job and the municipality, so ask the building department that covers your address what applies. Repiping usually needs a permit and an inspection.
Cast iron drains and other old pipe
Supply lines are one piece of the story. Older cast iron drain pipe can scale, crack and leak, and the repair is a section replacement or a larger drain replacement. See sewer line repair for what that involves.
If only one section is leaking, a spot repair may be enough. See burst pipe repair.
What affects the price of a repipe
We provide a written plan and a clear price before work starts.
- Size of the home
- More fixtures mean more pipe.
- Material
- PEX, copper and CPVC cost different amounts.
- Access
- Slab homes and tight attics take longer.
- Drywall and finishing
- Patching and paint are separate unless agreed.
- Permit and inspection
- Rules vary, so ask the City of North Miami Beach building department.
Insurance rarely covers a repipe unless a sudden event damaged the pipes. Want your real number? Call (305) 850-6382.
Questions we hear from North Miami Beach callers
Repeated leaks, rusty water and low pressure are signs. We assess before recommending.
It depends on the size of the house. We give a schedule in the plan.
Water is off for part of each day. We tell you when.
Yes, subject to association rules and building access.
Permit rules vary. Ask the building department.
Need a clear answer today?
Call and we will tell you what we would check first and what it usually takes.

